Like the heating and scraping, you should use the adhesive remover in small sections at a time, and re-apply the remover to the towel after you have done each section. To do this, add a small amount of adhesive remover to a microfiber towel, and rub the adhesive off. After the protective film has been entirely heated and scraped off, youвЂ™ll need to get rid of the adhesive that remains on the front of the car. Continue to heat a small section, and then scrape it away, until the entire clear bra has been removed. Step 4: Repeat the heating and scraping process. DonвЂ™t worry about the adhesive residue that will likely remain on the hood, as youвЂ™ll be getting rid of that later. Tip: Only worry about getting the protective film off of the car.Use the soft, non-metal scraper on the area that you just applied the heat gun to.Дepending on the clear bra, the whole section may come off at once, or you may have to scrape for a while to get all of the protective film off. Step 3: Use the scraper on the heated area. Warning: Always follow the manufacturerвЂ™s instructions when using the heat gun, and exercise extreme caution with this tool.You should hold the heat gun between 8 and 12 inches from the car, so as not to burn the clear bra.

Start with a small portion of the clear bra, and hold the heat gun over it for one or two minutes, until the protective film is sufficiently warmed up. When using the heat gun, you want to work in patches. Step 2: Use a heat gun or hot steam gun to apply heat. If the clear bra is coming off very slowly, in tiny pieces, then the process will take a little bit longer, and you will definitely need to use a heat gun. If the protective film comes off in large strips, then the next steps will be a little easier, and you can even skip the heat gun if youвЂ™d like. Use a soft, non-metal scraper, and start at a corner, where you can get underneath the protective film. To get a feel for how hard the process will be, try to scrape the bra away at one corner. Step 1: Gently try to scrape the clear bra away. Part 1 of 1: Remove the 3M protection film You may think that thereвЂ™s no fixing a clear bra that gets to this stage, but with a little bit of work and patience, you will be able to completely remove the 3M clear protection film, and get the front of your car back to looking the way it should. At this point the clear bra starts to become an eyesore, but it is also very difficult to remove. As this protection film ages, it becomes dry and brittle.

The clear bra is the 3M clear protection film that covers the front of your vehicle and helps protect it.

How to uninstall safe price